 |
| Start with a particle board to make the base board. |
 |
| With dimension and drill holes like this. |
 |
| Two 2x1 are used to install wheel casters. |
 |
| Drill holes. |
 |
| Bottom view of the base board. Two side bars with wheel casters are installed to the base board. |
 |
| The wheel castor (2-inch). |
 |
| Top view of the base board and the side bar with wheel casters. |
 |
| Top view of the base board and the side bars. The drill holes are for the 3-inch corner braces, which are used to hold the vertical aluminum angle. |
 |
| Install the vertical aluminum angle using corner braces. |
 |
| Install two 3-inch corner braces to the end of a one inch aluminum angle channel. The aluminum angle is 18" in length. |
 |
| Install the left hand side vertical aluminum angle channel to the base board. |
 |
| Insert four 1/4-20 x 1 screws through the base board. |
 |
| Turn over the base board. |
 |
| Install the nuts with washers. |
 |
| Install the right hand side vertical aluminum angle channel to the base board. |
 |
| Insert four 1/4-20x1 screws through the base board. |
 |
| Turn over the base board. |
 |
| Install the nuts with washers. |
 |
| The finished base board with caster wheels and two 18" vertical aluminum angle channels. |
No comments:
Post a Comment